When i write a 'm', but some points not in the rectangle.
After convert, the capture view not refresh.
How to let the capture refresh again? Not show the stroke.
Best Answer
O
Olivier @MyScript
said
almost 3 years ago
Dear User,
thank you for contacting us.
Currently, without more information about your implementation, it is difficult to provide with an accurate answer.
It is likely the ink is not considered to below to the capture layer... therefore the iink SDK will not clear it. How about havaing a bigger capture view (bigger than your writing area)?
Best regards,
Olivier
1 Comment
O
Olivier @MyScript
said
almost 3 years ago
Answer
Dear User,
thank you for contacting us.
Currently, without more information about your implementation, it is difficult to provide with an accurate answer.
It is likely the ink is not considered to below to the capture layer... therefore the iink SDK will not clear it. How about havaing a bigger capture view (bigger than your writing area)?
441083997
red rectangle is the capture view.
When i write a 'm', but some points not in the rectangle.
After convert, the capture view not refresh.
How to let the capture refresh again? Not show the stroke.
Dear User,
thank you for contacting us.
Currently, without more information about your implementation, it is difficult to provide with an accurate answer.
It is likely the ink is not considered to below to the capture layer... therefore the iink SDK will not clear it. How about havaing a bigger capture view (bigger than your writing area)?
Best regards,
Olivier
Olivier @MyScript
Dear User,
thank you for contacting us.
Currently, without more information about your implementation, it is difficult to provide with an accurate answer.
It is likely the ink is not considered to below to the capture layer... therefore the iink SDK will not clear it. How about havaing a bigger capture view (bigger than your writing area)?
Best regards,
Olivier